![Nitro portable 64 bit](https://cdn1.cdnme.se/5447227/9-3/screenshot_2_64e62946ddf2b36521902657.jpg)
Once installation is complete, there will be a virtual playback device called "Cable Input" and a virtual recording device called "Cable Output" in system's sound control panel: Step 1b: Extract the downloaded zip file and run the setup in administrative mode. Scroll down to the VB-Cable section and download the zip file for installation. Step 1a: Download the VB-Cable driver (donation-ware) from here. This is used to connect audio applications, and in this case connect the output of JRiver MC to TuneBlade.
![install vb cable install vb cable](https://www.paitgroup.com/hs-fs/hubfs/VB%20Cable.png)
Whatever is played at the Line-Out device (or playback device) can be recorded from the Line-in device (or recording device) of the pair. VB-Cable driver adds a pair of virtual audio devices, a Line-Out and a Line-In which are digitally connected.
![install vb cable install vb cable](https://i.ytimg.com/vi/VM5kqHliNnk/maxresdefault.jpg)
Step 1: Install VB-Cable (or HiFi-Cable or Virtual Audio Cable). Here are step-by-step instructions to create a connection between JRiver Media Center and TuneBlade: How to configure an AirPlay Zone in JRiver Media Center with TuneBladeīy default, TuneBlade is setup to capture system wide audio on the default audio playback device and transmit it over AirPlay, but it can also be set up to record audio from a single application, specifically applications which can render audio at any configured audio playback endpoint.
![Nitro portable 64 bit](https://cdn1.cdnme.se/5447227/9-3/screenshot_2_64e62946ddf2b36521902657.jpg)